| Use this inside corner support in conjunction with an outside corner support. The support has a gusset that adds strength to the dock. All of our dock hardware is made from hot dipped galvanized 1/4" steel. You can use lumber from 1-1/2" to 2-1/2" thick and 8", 10", or 12" high. The square holes are made for 1/2" carriage bolts. The Outside Corner is used for reinforcing the corners of a boat dock section. The assembly should be placed at the end of a dock section where no other section connects. If you plan to connect to another section later you may want to use male or female outside corners. The outside corner is designed to be used in conjunction with our Inside Corner Support. Failure to use the inside corner support will considerably decrease the strength of your boat dock. All of our hardware is designed to be fastened with 1/2-inch carriage bolts. The hardware is designed to be used with lumber from 1-1/2 to 2-1/2 inches thick. |
Assembly Requirements:
1 Outside Corner
1 Inside Corner
8 Carriage Bolt Assemblies